MACHINING.TRPrecision Machining. Engineered in Turkey.
Turning insert cutting a steel shaft
  1. Home
  2. Engineering
  3. Cutting Tools

Engineering

Cutting tools and parameters

The cutting tool is where machining happens. Its material, geometry and coating — and the cutting data chosen — decide productivity, surface quality and process security.

Tool materials

MaterialStrengthsTypical use
High-speed steel (HSS)Tough, sharp, low costTaps, small drills, special tools
Cemented carbideHard, versatile, coatableMost milling, turning and drilling
CermetFinish, edge stabilityFinish turning of steels
CeramicsHeat resistantCast iron, hardened steel, nickel alloys
CBNVery hard, heat resistantHard turning, hardened steels, cast iron
PCDExtreme wear resistanceAluminium with silicon, composites, non-ferrous

Coatings

PVD coatings such as TiAlN and AlTiN improve heat and wear resistance in steels and stainless; CVD coatings (TiCN, Al₂O₃) are common for steel turning; uncoated or DLC-coated polished tools suit aluminium and plastics to prevent built-up edge.

Tool wear and tool life

VBflank wear land VBcrater wearrake face
FIG.01Flank wear (VB) is the most common tool-life criterion. Crater wear points to excessive temperature.

Tool life is controlled mainly by cutting speed; feed and depth have a smaller influence. Monitoring wear, setting tool-life limits and changing edges before failure protect both part quality and machine.

Determining cutting data

  1. Start from the tool manufacturer's recommendation for the material group (ISO P, M, K, N, S, H).
  2. Adjust for stability: overhang, workholding, machine power and torque.
  3. Calculate spindle speed and feed — see the engineering calculators.
  4. Verify on the first part and optimise for tool life and finish.
ISO groupMaterials
P (blue)Steels
M (yellow)Stainless steels
K (red)Cast irons
N (green)Non-ferrous metals
S (orange)Heat-resistant alloys, titanium
H (grey)Hardened materials
ISO 513 material groups used for cutting-tool application.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry