Surface finish influences friction, sealing, fatigue, coating adhesion and appearance. Specifying the right parameter and value is just as important as specifying dimensions.
Ra and Rz
FIG.01Ra averages the profile deviations; Rz describes the average peak-to-valley height. Very different surfaces can share the same Ra.
Ra — arithmetic mean roughness. The most common parameter; robust but blind to isolated peaks or scratches.
Rz — mean of the maximum peak-to-valley heights of the sampling lengths. Better for sealing faces and where peaks matter.
Rmr / Rk family — bearing-ratio parameters for functional surfaces such as cylinder bores.
Roughness grades and achievable values
Roughness grade
Ra (µm)
Ra (µin, approx.)
Typical achievable by
N12
50
1,968
Sawing, flame cutting, rough forging
N11
25
984
Sawing, flame cutting, rough forging
N10
12.5
492
Rough turning / milling
N9
6.3
248
Rough turning / milling
N8
3.2
126
Standard turning / milling
N7
1.6
63
Finish turning / milling, reaming
N6
0.8
31
Fine finishing, grinding
N5
0.4
16
Grinding, honing
N4
0.2
8
Lapping, superfinishing, polishing
N3
0.1
4
Lapping, superfinishing, polishing
N2
0.05
2
Lapping, polishing
N1
0.025
1
Lapping, polishing
Grades per ISO 1302 (withdrawn N-grade notation, still common on drawings). Process ranges are typical, not guaranteed; they depend on material, tooling and set-up.
Drawing notation
The surface symbol (ISO 21920-1, formerly ISO 1302) states the parameter and limit, e.g. Ra 1.6; optional fields specify manufacturing method, lay direction and evaluation length. Without a parameter, a bare symbol only means "machined". Use the roughness converter for µm ⇄ µin and N-grades.
Choosing a value
Application
Typical requirement
Non-functional machined surfaces
Ra 3.2 – 6.3 µm
Mating faces, bolted joints
Ra 1.6 – 3.2 µm
Bearing seats, sliding fits
Ra 0.4 – 0.8 µm
Static O-ring grooves
Ra ≤ 1.6 µm (flanks), ≤ 0.8 µm (sealing face)
Dynamic seal running surfaces
Ra 0.2 – 0.4 µm, often with Rz and lay limits
Typical values for orientation; seal manufacturers' guidance takes priority.
Related pages
Enquiry
Have a drawing to review?
Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.