MACHINING.TRPrecision Machining. Engineered in Turkey.
Part transfer from main spindle to sub-spindle on a mill-turn centre
  1. Home
  2. Industries
  3. Robotics

Robotics

Robots depend on stiff, lightweight and precisely aligned machined components.

Robot arms, cobots and mobile robots use housings, flanges, shafts and gear components with high positional accuracy and low weight. End-of-arm tooling is often custom and produced in small batches.

Typical machined components

  • Joint and actuator housings
  • Tool flanges (ISO 9409-1 patterns)
  • Harmonic and planetary gearbox parts
  • Shafts and bearing spacers
  • End-of-arm tooling and grippers
  • Sensor and camera mounts
Part transfer from main spindle to sub-spindle on a mill-turn centre
Part transfer from main spindle to sub-spindle on a mill-turn centre

Common materials

  • EN AW-7075
  • EN AW-6082
  • 42CrMo4
  • 1.4305 (303)
  • POM-C
  • PEEK

Materials · Material Equivalents

Manufacturing processes

Machining challenges

  • Coaxiality of bearing bores through housings
  • Lightweight aluminium with thin walls
  • Accurate dowel and bolt patterns
  • Anodised surfaces with tight dimensions

Dimensional requirements

Bearing bores IT6–IT7 with coaxiality and perpendicularity controls; flange patterns with position tolerances.

Surface finish requirements

Ra 0.8 µm in bearing seats; cosmetic anodised surfaces with defined appearance criteria.

Inspection requirements

CMM measurement of coaxiality and position, first-article reports and appearance inspection.

Relevant standards

ISO 9409-1Manipulating industrial robots — mechanical interfaces: round flanges.
ISO 10218-1 / -2Safety requirements for industrial robots (part 1) and robot systems and integration (part 2).
ISO 1101Geometrical tolerancing — form, orientation, location and run-out; symbols, tolerance frames and their interpretation.
ISO 286-1 / -2ISO code system for tolerances on linear sizes: standard tolerance grades (IT) and fundamental deviations for holes and shafts; basis of fits such as H7/g6.
ISO 21920-1 / -2 / -3Current ISO standard for surface texture profile: drawing indication (part 1), terms and parameters (part 2), specification operators (part 3). Replaces ISO 1302 and ISO 4287/4288.

Engineering considerations

  • Account for anodising build-up in tolerances
  • Design housings for single-set-up machining
  • Use standard flange interfaces
  • Specify cosmetic surfaces clearly

Potential manufacturing solutions

Multi-axis milling and mill-turn for housings and shafts, coordinated anodising, and inspection of coaxiality and position.

Requirements depend on the specific part, drawing and customer specification. Sector approvals or certifications are not implied; where a project requires them, this is confirmed during the RFQ review.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry