Typical machined parts
- Pivot pins and bushings for booms and linkages
- Hubs, flanges and drive components
- Hydraulic cylinder parts and fittings
- Brackets, mounting plates and weld-on parts
- Rollers and wear parts
Typical requirements
| Topic | What the drawing usually asks for |
|---|---|
| Wear resistance | Induction-hardened or case-hardened pins and bushings, sometimes with hard chrome or nitriding |
| Fits under load | Pin-to-bushing clearances defined by the OEM, with lubrication grooves and grease holes |
| Large and heavy parts | Machining of forgings, castings and welded assemblies after stress relief |
| Corrosion protection | Painting, zinc plating or phosphating as specified |
| Traceability | Heat numbers and material certificates for structural and safety-relevant parts |

Standards often referenced
NoteThis page describes an application sector. It does not imply sector-specific approvals or existing customer references; requirements are reviewed for each drawing.