MACHINING.TRPrecision Machining. Engineered in Turkey.
End milling of an aluminium plate
  1. Home
  2. Industries
  3. Electronics

Electronics

Electronics hardware needs precise enclosures, thermal parts and conductive components.

Electronics manufacturers use machined enclosures, heat sinks, RF housings, connector pins and insulating parts. Cosmetic finishes, flatness of thermal interfaces and conductivity matter.

Typical machined components

  • Enclosures and covers
  • Heat sinks and cold plates
  • RF and microwave housings
  • Connector pins and contacts
  • Insulators and spacers
  • Panel parts
End milling of an aluminium plate
End milling of an aluminium plate

Common materials

  • EN AW-6061
  • EN AW-6082
  • Cu-ETP
  • CuZn39Pb3
  • PEEK
  • PTFE

Materials · Material Equivalents

Manufacturing processes

Machining challenges

  • Thin walls and fine pockets
  • Flatness of thermal interfaces
  • Copper burrs
  • Cosmetic anodising

Dimensional requirements

Flatness on thermal interfaces; fine pin diameters with tight tolerances.

Surface finish requirements

Ra 0.8–1.6 µm on thermal interfaces; cosmetic surfaces defined by appearance standard.

Inspection requirements

Dimensional and visual inspection; plating thickness via partners.

Relevant standards

RoHS 2011/65/EU · REACHEU restriction of hazardous substances in electrical and electronic equipment (RoHS) and chemicals regulation (REACH). Relevant e.g. to lead in free-machining brass and steel.
IEC 60529Degrees of protection provided by enclosures (IP code).
ISO 2768-1 / -2General tolerances for linear and angular dimensions (part 1: f, m, c, v) and for geometrical features without individual indications (part 2: H, K, L). Part 2 is being superseded by ISO 22081.
ISO 21920-1 / -2 / -3Current ISO standard for surface texture profile: drawing indication (part 1), terms and parameters (part 2), specification operators (part 3). Replaces ISO 1302 and ISO 4287/4288.
ISO 13715Indication of edges of undefined shape: burr, sharp edge and undercut tolerances on drawings.

Engineering considerations

  • Account for plating and anodising thickness
  • Specify cosmetic surfaces
  • Define flatness on interfaces
  • Specify RoHS compliance

Potential manufacturing solutions

Milling and Swiss-type turning with coordinated plating, anodising and appearance inspection.

Requirements depend on the specific part, drawing and customer specification. Sector approvals or certifications are not implied; where a project requires them, this is confirmed during the RFQ review.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry