Turbines, generators, pumps and switchgear rely on balanced rotating parts, pressure-retaining components and conductive parts made from copper alloys. Long service life makes material selection and traceability critical.
Typical machined components
- Shafts and rotor parts
- Blade roots and fixtures (to customer design)
- Valve stems, seats and bodies
- Bearing shells and bushings
- Copper busbars and contacts
- Seal rings and spacers

Common materials
Materials · Material Equivalents
Manufacturing processes
Machining challenges
- Run-out and balance requirements on rotating parts
- Heat-resistant steels and nickel alloys
- Burr-free, clean conductive copper parts
- Large diameter-to-length ratios
Dimensional requirements
Run-out and concentricity on rotating parts are often specified in hundredths of a millimetre; bearing fits follow ISO 286 classes.
Surface finish requirements
Bearing journals and seal surfaces commonly require Ra 0.4–0.8 µm, achieved by fine turning or grinding.
Inspection requirements
Run-out measurement, CMM inspection, hardness testing and material certificates. Balancing to ISO 21940-11 is arranged where required.
Relevant standards
| ISO 21940-11 | Mechanical vibration — rotor balancing: balance quality requirements for rotors in a constant (rigid) state (formerly ISO 1940-1). |
| EN 10204 | Types of inspection documents for metallic products: 2.1, 2.2, 3.1 and 3.2. The 3.1 certificate is the usual minimum for traceable machined parts. |
| ASME BPVC | ASME Boiler and Pressure Vessel Code (sections relevant to boilers, pressure vessels and materials). |
| ISO 1101 | Geometrical tolerancing — form, orientation, location and run-out; symbols, tolerance frames and their interpretation. |
| ISO 9001 | Quality management systems — requirements. |
Engineering considerations
- Define balancing requirements and grade
- Specify heat-treatment condition
- Identify critical rotating datums
- Specify plating for electrical contacts
Potential manufacturing solutions
Turning and multi-axis milling, grinding of journals through partners, and documented inspection including run-out.
Requirements depend on the specific part, drawing and customer specification. Sector approvals or certifications are not implied; where a project requires them, this is confirmed during the RFQ review.