MACHINING.TRPrecision Machining. Engineered in Turkey.
Multi-axis milling on a rotary table with flood coolant
  1. Home
  2. Industries
  3. Aerospace

Aerospace

Machined aerospace parts demand weight-optimised geometry, controlled materials and documentation that follows every part.

Aerospace components combine thin walls, deep pockets and complex datum structures with strict material and process control. Programmes typically require first article inspection, full traceability from mill heat to finished part and controlled special processes such as anodising or passivation.

Typical machined components

  • Brackets, fittings and clips
  • Actuator and valve housings
  • Hydraulic manifolds
  • Seat and cabin structure parts
  • Sensor and avionics housings
  • Ground-support equipment parts
Multi-axis milling on a rotary table with flood coolant
Multi-axis milling on a rotary table with flood coolant

Common materials

  • EN AW-7075
  • EN AW-2024
  • EN AW-6061
  • Ti-6Al-4V
  • 17-4PH (1.4542)
  • Alloy 718
  • PEEK

Materials · Material Equivalents

Manufacturing processes

Machining challenges

  • Thin walls and floors that deflect or chatter
  • Large stock removal (often > 80 %) with risk of distortion from residual stress
  • Titanium and nickel alloys with low thermal conductivity and high tool wear
  • Complex datum schemes requiring multi-axis access in few set-ups

Dimensional requirements

Profile and position tolerances on interfaces are typically tight — often a few hundredths of a millimetre — while non-functional pockets follow general tolerances. Tolerances are defined by the customer drawing and, where used, ASME Y14.5 or ISO GPS rules.

Surface finish requirements

Ra 1.6–3.2 µm is typical for machined surfaces, with finer values on seal faces and bearing bores. Surface integrity (no burn, no smeared layers) matters as much as roughness values on fatigue-critical parts.

Inspection requirements

Full dimensional reports against ballooned drawings, CMM measurement of datum-related features and documented first article inspection (AS9102 format where specified). Material certificates EN 10204 3.1 linked to heat numbers.

Relevant standards

EN 9100 / AS9100Quality management systems for aviation, space and defence organisations.
AS9102 / EN 9102Aerospace first article inspection (FAI) requirements and forms.
ASME Y14.5US standard for dimensioning and tolerancing (GD&T). Similar symbols to ISO, but different default rules (e.g. Rule #1 envelope principle).
ISO 1101Geometrical tolerancing — form, orientation, location and run-out; symbols, tolerance frames and their interpretation.
EN 10204Types of inspection documents for metallic products: 2.1, 2.2, 3.1 and 3.2. The 3.1 certificate is the usual minimum for traceable machined parts.

Engineering considerations

  • Specify stress-relieved plate (e.g. T651/T7351) to reduce distortion
  • Allow realistic corner radii and wall thicknesses for the chosen depth
  • Define datums that are accessible and functional
  • Call out special processes and their specifications explicitly

Potential manufacturing solutions

Multi-axis milling with balanced roughing, intermediate stress release and finishing in a single datum set-up; coordinated anodising, passivation or NDT through qualified partners; documented inspection before shipment. Sector approvals required by a programme are confirmed during the RFQ review.

Requirements depend on the specific part, drawing and customer specification. Sector approvals or certifications are not implied; where a project requires them, this is confirmed during the RFQ review.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry