MACHINING.TRPrecision Machining. Engineered in Turkey.
Turning insert cutting a steel shaft
  1. Home
  2. Materials
  3. Machinability

Materials

Machinability

Machinability describes how easily a material can be cut with acceptable tool life, forces, chip form and surface quality. It is not a single number — and it depends on condition as much as on alloy.

Factors that influence machinability

FactorEffect
Hardness and strengthHigher cutting forces and temperatures; lower speeds
Work hardeningSurface hardens in front of the edge (austenitic stainless, nickel alloys)
Thermal conductivityLow conductivity (titanium, nickel) concentrates heat at the edge
Abrasive phasesCarbides and inclusions wear tools (tool steels, cast iron, Ti-stabilised stainless)
DuctilityLong stringy chips and burrs (pure copper, low-carbon steel, aluminium 1xxx/5xxx)
Free-machining additionsSulphur, lead, bismuth or selenium improve chip breaking
Microstructure / conditionAnnealed vs. quenched & tempered changes everything

Machinability ratings

Traditional ratings compare materials with a reference free-cutting steel (e.g. AISI 1212 = 100 %). They are useful for orientation but depend on test conditions and do not translate directly to modern carbide tooling. Our materials reference uses a simple A–D scale instead.

Difficult materials — practical approach

  • Stainless steels: sharp positive geometry, constant feed (never rub), adequate depth to cut below the work-hardened layer.
  • Titanium: low cutting speeds, high-pressure coolant, sharp tools, rigid set-up; avoid dwell.
  • Nickel alloys: ceramic or carbide tools with careful speed control, frequent edge changes, trochoidal strategies.
  • Hardened steels: CBN and ceramic tools for hard turning; grinding for tightest tolerances.
  • Plastics: sharp polished tools, low clamping forces, allow for thermal expansion; anneal stock for tight tolerances.
VBflank wear land VBcrater wearrake face
FIG.01Typical tool wear modes. Flank wear grows steadily; crater wear indicates excessive heat and chemical reaction.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry