MACHINING.TRPrecision Machining. Engineered in Turkey.
Face milling with coolant through the tool
  1. Home
  2. Industries
  3. Energy

Energy

Energy equipment needs durable machined parts made from certified materials, often in large sizes and moderate volumes.

From wind and hydro equipment to transmission and process systems, energy projects use heavy flanges, housings, shafts and fittings. Material certification, corrosion protection and dimensional reliability matter more than extreme precision on most features.

Typical machined components

  • Flanges and adapter plates
  • Bearing housings
  • Shafts and couplings
  • Hydraulic cylinder parts
  • Cable and conduit fittings
  • Turbine and gearbox components
Face milling with coolant through the tool
Face milling with coolant through the tool

Common materials

  • S355J2
  • 42CrMo4
  • 1.4404 (316L)
  • 1.4462 (2205)
  • EN-GJS-400-15
  • CuAl10Ni5Fe4

Materials · Material Equivalents

Manufacturing processes

Machining challenges

  • Heavy parts requiring stable fixturing and lifting
  • Interrupted cuts on castings and weldments
  • Large bores with tight roundness
  • Corrosion protection and coating interfaces

Dimensional requirements

Bearing seats and sealing faces are tight; bolt patterns depend on position tolerance. Remaining dimensions are typically ISO 2768-m/c.

Surface finish requirements

Ra 1.6–3.2 µm on functional faces; Ra 3.2–6.3 µm elsewhere. Gasket faces may require a specific serration or finish.

Inspection requirements

Dimensional reports, EN 10204 3.1 certificates, and where specified 3.2 certificates or third-party inspection. NDT by partner laboratories.

Relevant standards

EN 10204Types of inspection documents for metallic products: 2.1, 2.2, 3.1 and 3.2. The 3.1 certificate is the usual minimum for traceable machined parts.
ISO 9001Quality management systems — requirements.
PED 2014/68/EUEU Pressure Equipment Directive — conformity of pressure equipment and assemblies.
ISO 2768-1 / -2General tolerances for linear and angular dimensions (part 1: f, m, c, v) and for geometrical features without individual indications (part 2: H, K, L). Part 2 is being superseded by ISO 22081.
ISO 1101Geometrical tolerancing — form, orientation, location and run-out; symbols, tolerance frames and their interpretation.

Engineering considerations

  • Specify machining allowances for castings and weldments
  • Define coating masking areas
  • Provide lifting and handling requirements
  • Clarify certificate type (3.1 vs. 3.2)

Potential manufacturing solutions

Combined casting, fabrication and machining through our manufacturing network, with machining of critical features after welding or stress relief.

Requirements depend on the specific part, drawing and customer specification. Sector approvals or certifications are not implied; where a project requires them, this is confirmed during the RFQ review.

Enquiry

Have a drawing to review?

Send your 2D drawing and 3D model with quantities, material and required documents. An engineer reviews manufacturability, tolerances and inspection before quoting.

What to include in your enquiry